4Pcs 550Cc Fuel Injector Nozzle Compatible With Civic Compatible With Accord Compatible With Acura B16 B18 B20 D16 D18 F22 H22 H22A B D H Series Engines

4Pcs 550Cc Fuel Injector Nozzle Compatible With Civic Compatible With Accord Compatible With Acura B16 B18 B20 D16 D18 F22 H22 H22A B D H Series Engines Typical Flow Rate in CC per minute: 550 CC/min @ 43.5 PSITypical Flow Rate in LB per hour: 48 LBS/HR @ 43.5 PSI: 12 ohms (High Impedance, High )Voltage: 8-15 Volts, nominal 13.5 VoltsThese High (Approx. 12 OHMS) Saturated fuel injectors will many applications, including, but not limited to:1986-1991 Compatible With Acura Integra (Must remove OEM resistor box, may need clips)1992-2001 Compatible With Acura Integra (1996+ REQUIRED Clips )1988-1997 Compatible With Accord 4 Cylinder Engines (Must remove OEM resistor box, may need clips)1998-2002 Compatible With Accord 4 Cylinder Engines (REQUIRED Clips )1988-1991 Compatible With Civic (Must remove OEM resistor box)1992-2000 Compatible With Civic (1996+ REQUIRED Clips )1988-1991 Compatible With CRX (Must remove OEM resistor box)1992-1995 Compatible With Del Sol1992-1996 Compatible With Prelude (Must remove OEM resistor box)1997-2001 Compatible With Prelude (1997+ REQUIRED Clips )Any OBD 0, OBD 1, B-Series, D-Series or H-Series EngineYou can always run these high injectors, even in a low setup.Amperage: 1.0 AmpsPressure: Min 30 PSIG / Compatible With Max 100 PSIGSpacers/O-rings Included: YES, on the injectorsElectrical connector type: EV1 (Minitimer, Jetronic)Overall Length: 3 inches, 76 mmTop O-ring: 11 mmColour:As shownMaterial:Plastic + MetalPackage Contents:4 x Fuel InjectorOrigin : Mainland ChinaWelcome to our store, here not only have the products you need, but also our warm service and professional advice, looking forward to meeting you!

• Able to respond quickly to changes in engine conditions. When the driver presses the accelerator pedal, the engine speed and load change instantaneously, the fuel injection nozzle can adjust the fuel injection amount and fuel injection time in a very short time.
• control of fuel injection timing. In a working cycle of the engine, the fuel injection nozzle needs to be injected at a crankshaft Angle.
• It can adapt to different fuel grades to a certain extent. The nozzle is designed to fuel of different and grade within a reasonable range.
• When the engine is cold started, the fuel injection nozzle will increase the amount of fuel injection according to the signal of the engine temperature sensor.
• Work with intake manifold, throttle and other intake system components. The amount of air intake will affect the amount of oil injection nozzle, and there is a close relationship between them.